Achieving Pool Perfection: Seamless Installation Of A Smonet Pool Cleaning Robots On Your Above Ground Pool

Views 1,111
May 14, 2024
Smonet

Introduction

The importance of a pool cleaners vacuum in a swimming pool cannot be overstated. It not only aids in maintaining cleanliness by filtering out dirt and debris but also helps prolong the life of your pool’s filtration system. Particularly, a SMONET skimmer, renowned for its durability and efficiency, makes an excellent addition to your above-ground pool. In this article, we will guide you step by step through the installation process of a SMONET skimmer.

Gather your tools:

SMONET skimmer set (including skimmer body, faceplate, and gasket)
Screwdriver
Sealant or Pool Putty
Utility Knife

Step 1: Preparation:

Start by lowering the pool water level about 4-6 inches below the skimmer cut-out location. This step prevents water from pouring out when installing the skimmer.

Step 2: Position The electric pool vacuum:

Position the SMONET skimmer body on the outside wall lining it up with the skimmer hole. Meanwhile, on the pool’s inside, align the skimmer gasket with the cut-out hole. The faceplate goes over the lining on the pool’s inside.

Step 3: Install The Skimmer:

Begin the installation by screwing in the corners of the faceplate. This process holds the assembly in place. You can then proceed to screw in the rest of the holes. It’s a good practice to apply sealant or pool putty around each screw hole before driving in the screws to create a watertight seal. Be careful no to overtighten the screws to avoid damaging the skimmer body or pool wall.

Step 4: Check The Seals:

Once all screws are in place, and the skimmer is secured to the wall, ensure that the seals around the skimmer are watertight. This check helps to prevent leaks that may degrade the pool wall over time.

Step 5: Attach The Skimmer Hose:

Now, it’s time to attach the skimmer hose to the bottom of the skimmer body. Ensure it is tightly secured with a hose clamp.

Step 6: Final Checks:

With your skimmer successfully installed, you are now ready to fill your pool back up and get your filter system running. Keep an eye on the new skimmer for a few days, looking out for any signs of leakage around its edges or if it’s effectively filtering out debris.

Installing a skimmer, notably a SMONET robotic cleaners for inground pools, on your above-ground pool not only enhances your pool’s cleanliness but also improves the quality of your swimming experience. While this may appear as a daunting task at first glance, with a little patience and this step-by-step guide, the process is relatively easy and straightforward.

Remember, regular maintenance of your pool’s filtration system, including your skimmer, is important to ensure that these components keep functioning efficiently and last a long time. With proper care and attention, you can enjoy the numerous benefits of having a refreshing and clean pool.