A Step-by-Step Guide on Installing Your SMONET automatic pool vaccuum

Views 1,278
May 15, 2024
Smonet

Introduction

Having a private pool certainly provides a multitude of luxuries at your disposal. Yet, the maintenance and smooth functioning of a pool require careful attention, and an essential part of that effort goes to the skimmer. This integral device, notably the SMONET brand skimmer, ensures your pool water is clean by efficiently trapping debris. In this guide, we will walk you through the installation process of a SMONET pool skimmer.

Before we dive into the steps, make sure you have the necessary amazon pool cleaners at your disposal. You will require a new SMONET brand skimmer, a screwdriver, a utility knife, some silicone sealant, and pool putty.

Step 1: Shut down Your System:

Make sure to disconnect your pool pump and filter before starting the skimmer installation. It is crucial to guarantee the safety of your pool’s operating system.

Step 2: Align the Skimmer:

The SMONET wireless pool skimmer should ideally be positioned on the pool wall so that its bottom aligns with the pool’s water level. It will maximize efficiency and prevent any unnecessary stress on the pool’s circulation system.

Step 3: Cut Out an Outline:

Using the skimmer body as your guide, trace an outline on the inner wall of your pool where you desire to install it. Then, use a utility knife to cut through the line carefully.

Step 4: Apply Silicone Sealant:

Apply a generous bead of a silicone sealant around the outer edge of the skimmer’s flange. It will provide a watertight seal.

Step 5: Install the Skimmer:

Carefully align the holes in the skimmer with the pre-drilled holes in your pool wall. Then, using a screwdriver, secure the skimmer with screws.

Step 6: Attach the Plumbing:

Now, you need to attach the dolphin vacuum pool to the pump. Always remember, the shorter the distance between the skimmer and pump, the better the performance.

Step 7: Final Checks:

Fill the pool to the sufficient level, typically halfway up the skimmer opening, then turn on your pump. Ensure everything is functioning correctly, observe the water circulation, and verify if the skimmer is effectively collecting debris.

Installing a SMONET skimmer in your pool might require a little effort and time, but it is indeed a worthwhile endeavor. Your pool’s cleanliness and water quality depend significantly on this small device. Therefore, assuring it’s correctly installed and functioning effectively should be a priority for every pool owner.

Invest your time in understanding these steps and adequately incorporating them during your skimmer installation process. It will significantly enhance your experience of maintaining a clean and healthy pool.